Go to the Indico Home Page Oldest event Older event Up to category Newer event Newest event
  • Indico style
  • Indico style - inline minutes
  • Indico style - numbered
  • Indico style - numbered + minutes
  • Indico Weeks View
    • Switch to the management area of this event
    Login

    Metal Additive Manufacturing Conference 2018

    21–23 Nov 2018
    Wirtschaftskammer Österreich
    Europe/Vienna timezone
    Registration is closed!

    Support

    Session

    New Materials (III)

    23 Nov 2018, 09:30
    Julius Raab Saal (Wirtschaftskammer Österreich)

    Julius Raab Saal

    Wirtschaftskammer Österreich

    Wiedner Hauptstraße 63 1045 Vienna, Austria

    Conveners

    New Materials (III)

    • Reinhart Poprawe (Fraunhofer - Institut für Lasertechnik ILT)

    Presentation materials

    There are no materials yet.

    1. 15. LASER POWDER BED FUSION OF ADVANCED HIGH STRENGTH STEELS - MODIFICATION OF DEFORMATION MECHANISMS BY INCREASING STACKING FAULT ENERGY
      Mr Simon Ewald (RWTH Aachen University - Digital Additive Production DAP)
      23/11/2018, 09:30
      New Materials
      Oral Presentation
      Within the field of Advanced High Strength Steels (AHSS), high-manganese Transformation- (TRIP) and Twinning-Induced Plasticity (TWIP) steels gained strong commercial interest by their outstanding mechanical properties. Previous studies have been shown that Laser Powder Bed Fusion (L-PBF) is a promising alternative to overcome shortcomings related to conventional processing routes of...
      Go to contribution page
    2. 16. FORMATION QUALITY, MECHANICAL PROPERTIES AND PROCESSING BEHAVIOR OF PURE ZINC (Zn) METAL PARTS PRODUCED BY LASERBASED MANUFACTURING FOR BIODEGRADABLE IMPLANTS
      Mr Maximilian Voshage (Digital Additive Production (DAP), RWTH Aachen University, Steinbachstraße 15, 52074 Aachen, Germany)
      23/11/2018, 09:50
      New Materials
      Oral Presentation
      Recent studies have shown that Zn based metal exhibit promising applications for biodegradable medical implants due to the good combination of biocompatibility, biodegradation rate and mechanical properties. Only a few recent reports can be found on additive manufacturing of Zn. Either the obtained density is too low, or the process window is quite narrow due to excessive evaporation. This...
      Go to contribution page
    3. 33. ADDITIVE MANUFACTURING OF NdFeB PERMANENT MAGNETS BY SELECTIVE LASER MELTING
      Mr Michael Görtler (Joanneum Research Forschungsgesellschaft mbH)
      23/11/2018, 10:10
      New Materials
      Oral Presentation
      Due to their high maximum energy product (BH)max, rare-earth permanent magnets made of Neodymium-Iron-Boron alloy (NdFeB) are widely used in industrial applications for sensors, electric drives or energy production and storage [1]. NdFeB magnets are mainly divided into sintered and polymer-bonded magnets. On the one hand, sintered magnets have the highest maximum energy product (BH)max, on...
      Go to contribution page
    Building timetable...