Go to the Indico Home Page Oldest event Older event Up to category Newer event Newest event
  • Indico style
  • Indico style - inline minutes
  • Indico style - numbered
  • Indico style - numbered + minutes
  • Indico Weeks View
    • Switch to the management area of this event
    Login

    ESSC & DUPLEX 2019

    30 September 2019 to 2 October 2019
    Schloss Schönbrunn
    Europe/Vienna timezone
    <a href="https://asmet.org/event/essc-duplex-2019/" target="_blank">Registration is closed!

    Support

    Session

    Surface properties

    1 Oct 2019, 14:20
    Schloss Schönbrunn

    Schloss Schönbrunn

    Apothekertrakt, Vienna

    Conveners

    Surface properties

    • Matthias Sorg (Institute for Materials System Technology Thurgau)

    Presentation materials

    There are no materials yet.

    1. 11. MAGNETIC EFFECTS ON AUSTENITIC STAINLESS STEELS AFTER A LOW TEMPERATURE CARBURIZATION
      Philipp Schuler (Institute for Materials System Technology Thurgau at the University of Applied Sciences Konstanz)
      01/10/2019, 14:20
      Surface properties
      Oral Presentation
      Austenitic stainless steels have a very good combination of mechanical properties e.g. formability associated with corrosion resistance. Due to the cubic face-centered lattice at room temperature, these steels are not magnetizable and a conventional hardening is not possible. Due to the low hardness, these steels are not optimal for tribological stress and in many cases show low performance....
      Go to contribution page
    2. 12. PITTING SUSCEPTIBILITY OF METASTABLE AUSTENITIC STAINLESS STEELS AS A FUNCTION OF SURFACE CONDITIONS
      Arnulf Hörtnagl (Institute for Materials System Technology Thurgau)
      01/10/2019, 14:40
      Surface properties
      Oral Presentation
      The influence of surface roughness and local defects on pitting susceptibility of type 304 (UNS S30400) and type 301 (UNS S30100) in chloride solution were investigated. Because the mechanical properties can be regarded as decisive for the aachieved surface quality, different properties of the base material were obtained by cold rolling the metastable austenites. This was done before the...
      Go to contribution page
    3. 37. NEW DEVELOPMENTS IN HIGH TEMPERATURE SOLUTION NITRIDING OF STAINLESS STEELS
      Thomas L. Christiansen (Technical University of Denmark (DTU), Department of Mechanical Engineering)
      01/10/2019, 15:00
      Surface properties
      Oral Presentation
      High temperature solution nitriding (HTSN) of stainless steel was originally developed by Prof. Berns in the early 1990s and is in many aspects the “stainless” analogue to carburizing of steels. The process entails dissolution of nitrogen in stainless steel at temperatures above, say, 1050°C, from an atmosphere consisting of molecular nitrogen at a fixed partial pressure. Austenitic, ferritic,...
      Go to contribution page
    4. 67. DATA DRIVEN CONTINUOUS QUALITY MONITORING IN ROLLING MILLS
      Mr Hans Peintinger (QuinLogic GmbH)
      01/10/2019, 15:20
      Surface properties
      Oral Presentation
      Over the past decades, huge volumes of quality data collected through continuous and regular monitoring of individual processing lines from the rolling industry have been accumulated. Now is the time to reap returns on past investments made in expensive and precise quality measuring equipment. These data await being put to better use. Any anomalous or divergent quality data require an...
      Go to contribution page
    Building timetable...